Terminal Chamfering Machine
Model: OT-100 series
Category: Gold Finger Beveling Machine
Exhibitor: DER LIH FUH CO., LTD.
Booth No: TBA
Characteristic
A.With up and low spindle it can overcome lightly board bending or thickness error. B. 1.EQ error can be controlled within ±0.05mm (45 degree) 2.If board bending, thickness error more than 0.05mm less than 0.1mm. Accuracy can be controlled within ±0.1mm. C.PCB board thickness 2.0, 1.8 both can apply to spec. D.Use Electronic spindle with RPM spec 0~50000 rpm/min so our machine can get higher , , more stable quality.
Other Products
-
Large vacuum pumps
-
DRILL + TWO PIN MACHINE
-
Vertical dry film development equipment
-
Roll to Roll Automatic Punching Machine
-
IC carrier Tray intelligent retractable board machine
-
SINGLE-COMPONENT SOLDER STRIPPER
-
Replenisher PM
-
Ultrathin FCCL (2L-FCCL)-use Polyester substrate
-
Auto-Alignment UV-LED Exposure Units(for inner layer / outer layer)
-
日本 SANSO PUMP PMD-581 耐酸鹼泵浦
